WOD Engraved Transfer Case Shifter Knob

Common Applications:

• Atlas Transfer Cases
• NP205 Transfer Cases
• NP205 Colossus Transfer Cases
• Dana 300 Transfer Cases
• Stak Transfer Cases
• Custom twin-stick transfer case shifters

Fitment Notes:

• Requires a 1/2"-13 threaded shifter stick
• Verify shifter thread size before ordering
• Choose Standard or Reverse pattern to match the direction of your shifter
• Sold individually; most twin-stick installations require quantity (2)

What's the difference between Standard and Reverse pattern?

The difference is the order of the engraved shift positions. The Standard Pattern reads H-N-L, while the Reverse Pattern reads L-N-H. Choose the version that matches the actual movement of your transfer case shifter so the engraving correctly identifies High, Neutral, and Low from the driver's seat.

Why would I need one Standard and one Reverse knob?

Twin-stick transfer case installations do not always have both shifter sticks operating in the same direction. Depending on the transfer case, linkage, and how the shifters are packaged in the chassis, one lever may use a Standard pattern while the other uses a Reverse pattern. Check the movement of each shifter before ordering.

How do I know if these knobs will fit my shifters?

Check the threads at the top of your transfer case shifter sticks. These knobs are tapped 1/2"-13. If your shifter uses the same thread size, the knob can thread directly onto the stick.

Do I need one or two knobs?

Each knob is sold individually. A typical twin-stick transfer case uses two shifter knobs, so order quantity (2) for a complete setup. This also allows you to mix Standard and Reverse patterns when your shifter configuration requires it.